Formulary

AP Roll-On "SenSoft"

March 1, 2009


Phase A
Emulgade NLB
5.0
Cetiol SenSoft (Propylheptyl caprylate (proposed)
4.5
Dimethicone
1.5

Phase B
Water, demin.
49.0

Phase C
Aluminum chlorohydrate
40.0

Procedure
Heat phase A to 80°C. Heat phase B to 80°C and add to phase A while stirring. Allow the emulsion to cool while stirring in such a way that it remains in continual motion. Avoid incorporation of air. Stir while cooling to 45°C and add phase C. Stop stirring at 35-30°C when you observe that the viscosity increased.

pH-value (as is): 4.0


More Information
Cognis GmbH, Care Chemicals Div., Rheinpromenade 1 D-47089 Monheim, Germany
Website: www.cognis.com
blog comments powered by Disqus
  • Back to School

    Back to School

    Tom Branna, Editorial Director||September 1, 2016
    It may be September, but class was in session this summer during the Private Label Manufacturers Association’s Executive Educ

  • New Surfactants

    Tom Branna, Editorial Director ||September 1, 2016
    Here’s a list of new ingredients introduced by surfactant suppliers

  • What

    What's In Your Formula?

    Christine Esposito, Associate Editor||September 1, 2016
    A look at the ingredients beauty brands are using to fuel their formulations and capture consumers’ attention.