Formulary

Moisturizing and Brightening BB Cream

Provided by Sandream Impact.

Released by Sandream Impact 05.01.19

Phase A
Zemea (Dupont Tate & Lyle) (Propanediol)	5.00
Glycerin (Jeen) (Glycerin 99.7% USP)	4.00
Carbopol 940 (Lubrizol) (Carbomer)	0.50
Phase B
Deionized water	50.29
Phase C
PureSyn 6 (Sandream) (Hydrogenated polydecene)	6.00
Jarcol I-20 (Jarchem) (Octyldodecanol)	5.00
NOO Crystal (Sandream) (Octyldodecyl oleate, tocopheryl acetate)	5.00
Cetyl Alcohol NF (Jeen) (Cetyl alcohol)	3.00
Arlacel 165-NV-PW-AP (Croda) (Glyceryl stearate; PEG-100 stearate)	3.00
Avocado Oil (Jeen) (Persea gratissima oil)	1.00
Vitamin E (Sandream) (Tocopheryl acetate)	1.00
Phase D
Ecoperse White TiO2 (Sandream) (Octyldodecyl Oleate, Titanium Dioxide)	4.40
Ecoperse IO Red (Sandream) (Octyldodecyl oleate, red iron oxide)	0.40
Ecoperse IO Black (Sandream) (Octyldodecyl oleate, black iron oxide)	0.30
Bichroma Yellow (Sandream) , (Bismuth oxychloride, mica, iron oxides, magnesium stearate)	3.00
Bichroma Diamond (Sandream) (Bismuth oxychloride, mica)	1.00
Phase E
Deionized water	5.00
Hyaluronic Acid 1-1.5 Mil Dalton (Sandream) (Hyaluronic acid)	0.10
RKG (Sandream) (Raspberry ketone glucoside)	0.10
Disodium EDTA (Sandream) (Disodium ethylenediaminetetraacetic acid)	0.01
Phase F
Green Tea Callus Stem Cell (Sandream) (Camellia sinensis callus culture extract, 1,2 -hexandiol, sodium hyaluronate, ethylhexylglycerin, water)	0.50
AMPD Ultra PC Neutralizer (Angus) (Aminomethyl propanol)	0.40
Euxyl PE 9010 (Schulke) (Phenoxyethanol, ethylhexylglycerin)	1.00
Procedure
Weigh an empty glass beaker suitable for batch size and record the weight. Dissolve carbopol in glycerin and Zemea (phase A). Preheat phase B (water) to 65-70°C. Add phase B to A and mix under heat, maintaining temperature at 65-70°C until all raw materials are dissolved, and swelling is complete. Premix phase C in a separate beaker and heat to 65-70°C until all is dissolved and uniform. Add phase D to C and mix under rapid propeller mixing until all is dispersed, and a homogeneous solution is present. Add phase DC to AB and homogenize under moderate speed for 10 minutes. After emulsion is complete, remove from heat and bring back to propeller mixing. Pre-dissolve phase E in a small beaker and add to main batch. Finally, add phase F and mix until fully incorporated. Reconstitute the batch with deionized water to compensate for water loss.
More Information
Sandream Impact Tel: 973-822-3077 Website: www.sandreamimpact.com